TM 5-5420-227-24
TONGUE CYLINDER REPAIR (Sheet 1 of 5)
PROCEDURE INDEX
PROCEDURE
PAGE
Disassembly
Cleaning and Inspection
Assembly
TOOLS:
Ratchet with 3/4 in. drive
Snap ring pliers
1-5/16 in. socket with 3/4 in. drive
7/16 in. socket with 1/2 in. drive
Torque wrench with 3/4 in. drive
Ratchet with 1/2 in. drive
(0 to 600 lb-ft capacity) (0-813 Nm)
Hammer
Spanner wrench with 0-6-1/2 in. span
Punch, drive pin 3/4 x 10 in.
Flat-tip screwdriver
4-9/16 in. cylinder rod wrench (stow right fender box)
Crowbar
Dry cleaning solvent (Item 15, Appendix D)
SUPPLIES:
Rags (Item 12, Appendix D)
Masking tape (Item 18, Appendix D)
10/32 screw 1/2 in. long (4 required)
Packing assembly
Wiper ring (2 required)
Preformed packing
Spacer ring
Wooden block 6 in. by 6 in. by 36 in. long
Container (to catch fluid)
Two
PERSONNEL:
REFERENCES:
DISASSEMBLY:
Place wooden block under forward
1.
end of tongue cylinder (A).
Go on to Sheet 2
TA170553
4-77