TM 5-5420-228-24
EJECTION CYLINDER HOSE ASSEMBLIES (CA, CB, CC, AND CD) AND HYDRAULICS
REPLACEMENT (Sheet 4 of 7)
150
Using socket, remove eight screws (U) and
16.
Remove boom mount hose armor (W).
Holding two elbows (X) with 3/4 inch
wrench, use 7/8 inch wrench to remove hose
assemblies "CD" (N) and "CC" (G).
Using 3/4 inch wrench on elbows (X), use 7/8
inch wrench to loosen elbow nuts (Y).
Using adjust able wrench, remove two
elbows (X), elbow nuts (Y), flat washers
(Z) and preformed packings (AA). Throw
away preformed packings (AA) away.
NOTE
Before installation, use pipe tape on all male threads. Start tape on second
thread so tape will not enter hydraulic system.
Go on to Sheet 5
TA251557