TM 5-5420-228-24
LOCK I N G CY LI N DER REPLACEM EN T (She e t 2 of 3 )
Remove locking cylinder (H) from vehicle.
5.
6 . Using 7/8 inch wrench, remove hose
assembly (J) from two elbows (K).
7.
Using 3/4 inch wrench, remove two elbows
(K) and collars (L) from locking cylinder (H).
Using 3/4 inch wrench, remove nipple (M)
8.
and its attached parts from locking cylinder
(H).
INSTALLATION:
N OT E
Be fore inst a lla t ion, use pipe t a pe on a ll m a le pipe
t hre a ds. St a rt t a pe on second thread so tape will not
enter hydraulic system. Remove all caps and plugs as
necessary during installation.
1.
Using 3/4 inch wrench, install nipple (A) and
its attached parts on locking cylinder (B).
N OT E
Colla r (C), m a rk e d "M " iS use d w it h
e lbow (D) a nd c olla r (E), m a rk e d "CE2 "
is use d w it h e lbow (F).
Using 3/4 inch wrench, install two elbows
2.
(D, F) and collars (C, E).
TA251632
Go on to Sheet 3
