TM 5-5420-228-24
DRIVER'S HATCH NIGHT VIEWER LATCH REPLACEMENT (Sheet 3 of 5)
CLEANING AND INSPECTION:
1.
Using putty knife and steel wool, remove old sealant and adhesive from hatch and all
parts.
Using dry cleaning solvent rags, remove remaining debris and dirt.
2.
3.
Inspect all parts for damage or wear. Replace defective parts.
INSTALLATION :
With putt y knife, apply adhesive (Item 4,
1.
Appendix D) to one side of new gaskets (A)
and (B). Apply adhesive to mating surfaces
on hatch (C) and plate (D).
2.
When adhesive is tacky, aline and apply new
gasket and new pad (B).
3.
Place new lockwashers (E) on two screws (F)
and apply sealing compound to screw threads.
NOTE
Before performing step 4, get
another person to help aline holes in
plate (D) and latch mechanism (G)
with holes in hatch (C).
Using fingers, start screws (F) through hatch
4.
(C) into latch mechanism (G).
5.
Using 3/4 inch socket and torque wrench,
tighten two screws (F) to 95-125 lb-ft (128-169
N.m).
TA251764
Go on to Sheet 4
