TM 5-5420-278-100021 000021 00-1UNLOADING BAP TO GROUNDCAUTIONAssistant will act as ground guide when maneuveringCPT and during operation of the LHS. Failure tocomply may result in damage to equipment.NOTEDuring all transporter operations, the CBT operatorwill drive and be responsible for the operation of theLHS via the cab and remote control boxes. Theassistant will act as a ground guide, be responsible fordirecting the operator using hand signals, and assistthe operator as needed.a. Position CBT so that rear of vehicle is approximately 16 ft. (4.9 m) in front ofwhere BAP is to set on ground, apply service brake (3), move transmissionselector lever (2) to N (neutral), and pull parking brake control (1) out.WARNING The winch frame must be locked to the BAP prior tounloading BAP to ground. Failure to comply may resultin damage to equipment or injury to personnel.NOTEWhen both levers are in the UP position, the winch frameis locked to the BAP. Perform steps b and c if levers arein the DOWN position.b. Remove quick-release pin (5) from stud (7) at both sides of winch frame (6).c. Swing lever (8) up so that end of stud (4) is through hole in lever (8), andinstall quick-release pin (5) on stud (4) at both sides of winch frame (6).13784562
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business