TM 5-5420-278-10
0020 00
0020 00-7
LOADING BAP FROM GROUND (Contd)
NOTE
The LHS ENGAGED indicator will light up whenever
the joystick is held in the LOAD or UNLOAD position.
o. Hold joystick (3) in UNLOAD position until end of LHS hook arm (8) is below
BAP hook bar (7), then release joystick (3). The NO TRANSIT WHEN LIT
indicator (2) will light.
p. Turn HIGH IDLE switch (4) to OFF position.
CAUTION
Ensure HIGH IDLE switch is in OFF position prior to
putting vehicle transmission in gear, or damage to
transmission may result.
q. Back up CBT until end of hook arm (8) is centered directly under BAP hook
bar (7), apply service brake (11), move transmission selector lever (10) to N
(neutral), and pull PARKING BRAKE control (9) out.
CAUTION
If hook end of LHS hook arm is not properly connected
to BAP hook bar, assistant must immediately signal
operator to stop loading procedure. Move CBT forward
and repeat steps k through q, or damage to equipment
may result.
r. Hold joystick (3) in LOAD position until LHS hook arm (8) is fully connected to
BAP hook bar (7), then release joystick (3).
s. Turn HIGH IDLE switch (4) to ON position.
t. Push PARKING BRAKE control (9) in.
7
9
11
10
8
