TM 5-5420-278-10
0021 00
0021 00-7
UNLOADING BAP TO GROUND (Contd)
NOTE
CBT should be in neutral and parking brake released to
allow transporter to roll forward when unloading BAP.
p. Hold joystick (5) in UNLOAD position until front end of BAP (8) is
approximately 1 ft (0.3 m) from ground, then release joystick (5).
q. Turn HIGH IDLE switch (3) to OFF position.
r. Hold joystick (5) in UNLOAD position until front end of BAP (8) rests on
ground, then release joystick (5) and set parking brake by pulling PARKING
BRAKE control (9) out.
CAUTION
Ensure HIGH IDLE switch is in OFF position prior to
putting vehicle transmission in gear or damage to
transmission may result.
NOTE
If LHS hook arm does not disengage, drive CBT
forward 2 in. ( 5 cm) and repeat step s.
s. Hold joystick (5) in UNLOAD position until end of LHS hook (7) is fully
disconnected from BAP hook bar (6).
t. Push PARKING BRAKE control (9) in and drive CBT forward 5 ft (1.5 m),
apply service brake (11), move transmission selector lever (10) to N (neutral),
and set parking brake by pulling PARKING BRAKE control lever (9) out.
6
7
8
9
10
11
