MANUALLY LOADING BAP FROM GROUND (cont)

MANUALLY LOADING BAP FROM GROUND (cont) - TM-5-5420-278-10_392

MANUALLY LOADING BAP FROM GROUND (cont) - TM-5-5420-278-10_394

TM-5-5420-278-10 M85 Tank Chassis Transporting: for Bridge Armored-Vehicle-Launched Scissoring Type Class 80 Manual
Page Navigation
345

TM 5-5420-278-10 0047 00 0047 00-5 MANUALLY LOADING BAP FROM GROUND (Contd) CAUTION Ensure HIGH IDLE switch is in OFF position prior to placing vehicle transmission in gear, or damage to transmission may occur. If hook end of LHS hook arm is not properly connected to BAP hook bar, assistant must immediately signal operator to stop loading procedure. Move CBT forward and repeat steps o and p, or damage to equipment may result. o. Back up CBT until end of hook arm (6) is centered directly under BAP hook bar (5), then apply service brake (9), move transmission selector lever (8) to N (neutral), and pull PARKING BRAKE control (7) out. p. Hold joystick (3) in LOAD position until LHS hook arm (6) is fully connected to BAP hook bar (5), then release joystick (3). q. Push PARKING BRAKE control (7) in. 9 8 7 5 6

Privacy Statement
Press Release
Contact