MANUALLY UNLOADING BAP TO GROUND (cont)

MANUALLY UNLOADING BAP TO GROUND (cont) - TM-5-5420-278-10_400

MANUALLY UNLOADING BAP TO GROUND (cont) - TM-5-5420-278-10_402

TM-5-5420-278-10 M85 Tank Chassis Transporting: for Bridge Armored-Vehicle-Launched Scissoring Type Class 80 Manual
Page Navigation
352

TM 5-5420-278-10 0048 00 0048 00-5 MANUALLY UNLOADING BAP TO GROUND (Contd) NOTE CBT should be in neutral and parking brake released to allow transporter to roll forward when unloading BAP. p. Hold joystick (3) in UNLOAD position until front end of BAP (10) is approximately 1 ft (30.5 cm) from ground, then release joystick (3). q. Move HIGH IDLE switch (4) to OFF position. r. Hold joystick (3) in UNLOAD position until front end of BAP (10) rests on ground, then release joystick (3) and set parking brake by pulling PARKING BRAKE control (5) out. CAUTION Ensure HIGH IDLE switch is in OFF position prior to putting vehicle transmission in gear or damage to transmission may result. NOTE If LHS hook arm does not disengage, drive CBT forward 2 in. (5 cm) and repeat step s. s. Hold joystick (3) in UNLOAD position until end of LHS hook (9) is fully disconnected from BAP hook bar (8). 1 2 4

Privacy Statement
Press Release
Contact