TM 5-5420-278-10
0051 00
0051 00-1
MANUALLY REMOVING LOAD DURING LHS POWER LOSS
NOTE
Manual mode operations using the cab control box are
to be performed only when normal AUTO SEQUENCE
mode electric circuit is not operating.
This procedure is used to remove load from transporter
with a failed LHS or other failure that prevents
operation of LHS.
Each transporter is equipped with one hose assembly
stowed in left-hand stowage box on transporter. Two
hose assemblies (one from each vehicle) are required.
a. Position transporters so LHS control boxes (1) on both transporters are side
by side.
b. Shut off engines on both transporters.
NOTE
Refer to figure 1, Transporter Hose, for steps
c through g.
Figure 1. Transporter Hose Flow Diagram.
1
