TM 5-5420-278-24&P0024 000024 00-4UNFOLDING STABILIZER AND BRACKETS REPLACEMENT (Contd)INSTALLATIONNOTEInstallation of left and right unfolding stabilizer and brackets isperformed the same way. Right side is shown. Apply a light coat of grease to pins at installation.1.Install spacer plates (10) and bumper (11) on inner ponton (1) with screw (12).2.Install pin (8) on connecting link (7).3.If removed, install dowel pin (9) on each rail bracket (2).4.Install two inner ponton rail brackets (2) and connecting link (7) on inner ponton (1) with four washers (3) and screws (4).5.Install washer (6) and screw (5) on each dowel pin (9).6.Repeat steps 1 through 5 to install bumper, rail brackets, and connecting link on outer ponton.7.Install two hinge brackets (14) on stabilizer bracket (15) with two pins (13).8.Position spacer(s) (20) in recess of inner ponton (1).NOTEAssistant will help with steps 9 and 10.9.Install stabilizer (29) on inner ponton (1) by positioning hinge bracket (14) and spacers (16) in recess on inner ponton (1) and installing four washers (18) and screws (17). Do not tightenscrews (17).10.Align stabilizer bracket (28) and inner ponton (1), and install pin (25) and two spacers (27) on innerponton (1) and stabilizer bracket (28).11.Align hole in pin (25) with hole in inner ponton (1), and install screw (24) on pin (25).12.Install screw (26) on pin (25).13.Turn stopscrew (19) counterclockwise until spacers (16) contact edge of recess on inner ponton (1),then tighten four screws (17).14.Connect inner ponton connecting link (7) to stabilizer bracket (15) with pin (21), washer (22), andscrew (23).15.Connect outer ponton to inner ponton (WP 0023 00).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
