TM 5-5420-278-24&P0038 000038 00-2BLEEDING PUMP SYSTEM (Contd)NOTEBleeding of fluid on both pumps is performed the same way.Right-hand inner ponton pump is shown.PUMPWARNINGAccidental or intentional introduction of liquid contaminants intothe environment is in violation of state, federal, and militaryregulation. Refer to Army POL (WP 0001 00) for informationconcerning storage, use, and disposal of these liquids. Failure todo so may result in injury or death.CAUTIONCap or plug all hoses, connections, and openings immediatelyafter disconnection to prevent contamination. Remove caps orplugs prior to installation. Failure to do so may result in damageto equipment.NOTETag hoses for installation.Have container ready to catch fluid.1.Open access cover (3) and place control lever (2) on pump (5) to TRANSPORT/CROSSING position.2.Install handle (1) on pump (4) and operate handle (1) approximately 30 strokes to bleed pump (5).3.Remove filler cap with dipstick (6) from pump reservoir (4) and check fluid level using filler cap dipstick (6).4.Position filler cap plug threads (7) onto reservoir opening (9) with threads on top of opening (9) tocheck level, and fill reservoir (4) to max position on dipstick (8) if necessary.5.Check gasket seal (10) on filler cap with dipstick (6) for damage and replace if necessary.6.Install filler cap with dipstick (6) on pump reservoir (4).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business