TM 5-5420-278-24&P
0072 00
0072 00-6
CYLINDER MAINTENANCE (Contd)
ASSEMBLY
NOTE
Apply fluid to seal rings, piston, piston rod, and O-rings at
assembly.
1.
Apply sealing compound to threads of plugs (21) and (26) and install plugs (21) and (26) on cylinder
end yoke (25), piston rod (22), and cylinder housing (9).
2.
Install new bushing (27) in cylinder housing (9) with snap ring (25).
3.
Install three new piston rod seals (10) and new scraper (11) in cylinder housing (9).
4.
Slide piston rod (12) in cylinder housing (9).
5.
Install new piston guide ring (16), new piston seal ring (17), new O-ring (18), new support ring (19),
and new piston seal ring (20) on piston (22).
6.
Install piston (19) in cylinder housing (9) and screw piston rod (12) into piston (22).
7.
Install plug (15) and new lockwasher (14) on piston (19) and piston rod (12).
8.
Install two piston rod seal rings (23) and new O-ring (24) on cylinder end yoke (25).
9.
Apply sealing compound to threads of end yoke (25) and install cylinder end yoke (25) on piston (22)
and cylinder housing (9).
10.
Install new O-ring (7), fitting (30), and tube (2) on cylinder housing (9) with screw (29).
11.
Install fluid lock assembly (6) with tube (2) on cylinder housing (9) with new O-ring (8), four new
lockwashers (5), and screws (4).
12.
Tighten nuts (1) and (3) on tube (2).
13.
Install cylinder (WP 0036 00).
14.
Install pump (WP 0035 00).
15.
Fill fluid system (WP 0032 00).
16.
Bleed fluid system (WP 0038 00).
17.
Connect inner pontons, if separated (WP 0023 00), or fold ramp bay (TM 5-5420-278-10).
18.
Install ramp bay on transporter (TM 5-5420-278-10).
