TM 5-5420-278-24&P
0083 00
0083 00-3/4 blank
NOTE
The “L” maintenance level is not included in column (4) of the
MAC. Functions to this level of maintenance are identified by a
worktime figure in the “H” column of column (4), and an
associated reference code is used in the REMARKS column (6).
This code is keyed to the remarks and the SRA complete repair
application is explained there.
Column (5) – Tools and Equipment Reference Code. Column (5) specifies, by code, those common
tool sets (not individual tools), common Test, Measurement and Diagnostic Equipment (TMDE), and special
tools, special TMDE, and special support equipment required to perform the designated function. Codes are
keyed to the entries in the tools and test equipment table.
Column (6) – Remarks Code. When applicable this column contains a letter code, in alphabetical
order, which is keyed to the remarks table entries.
EXPLANATION OF COLUMNS IN THE TOOLS AND TEST EQUIPMENT REQUIREMENTS
Column (1) – Tool or Test Equipment Reference Code. The tool and test equipment reference code
correlates with a code used in column (5) of the MAC.
Column (2) – Maintenance Level . The lowest level of maintenance authorized to use the tool or test
equipment.
Column (3) – Nomenclature. Name or identification of the tool or test equipment.
Column (4) – National Stock Number (NSN). The NSN of the tool or test equipment.
Column (5) – Tool Number. The manufacturer’s part number, model number, or type number.
EXPLANATION OF COLUMNS IN THE REMARKS
Column (1) – Remarks Code. The code recorded in column (6) of the MAC.
Column (2) – Remarks . This column lists information pertinent to the maintenance function being
performed as indicated in the MAC.
END OF WORK PACKAGE
