TM-5-5420-279-10
Position of Mudguard R clips
4.3.2.6
Remove the two transportation securing straps restraining the tail lift.
4.3.2.7
Remove the tail lift pendant with the attached umbilical cable from its stowage.
4.3.2.8
Remove the dust cover from the tail lift umbilical connection mounted at the left side
of the launch vehicle, aft of the fifth wheel axle.
4.3.2.9
Check the emergency stop button on the tail lift pendant is released by turning the
knob counter-clockwise in the direction of the arrows.
4.3.2.10
Connect the tail lift umbilical cable to the tail lift vehicle connection point.
4.3.2.11
In the launch vehicle cab, to the right of the driving position, on the left side of the
center console, set the 4-position mode selector rotary switch from position 1 to
position 2. Make sure the engine rpm goes to high idle.
TRANSFER CASE
LOCKUP
ENGAGEONLYWHENCTIS/LOCKUP
SELECTIONDOESNOTPROVIDE
3
2
SUFFICIENTTRACTIONFORCONDITION.
RETURNTRANSFERCASETOTHE
UNLOCKEDPOSITIONASSOONAS
CONDITIONSALLOW
4
CAUTION
DONOTENGAGETRANSFERCASE1
LOCKUPWHILEWHEELSARESLIPPING
ORWHENTURNINGACORNER,
DAMAGETODRIVELINEMAYRESULT
ROTARY SWITCH
12VDC
24VDC
EMERGENCY STOP OVERRIDE
AUX
AUX
Pos
Function
WARNING
1
Highway
Check Aux
Light Off
WHENSET,EMERGENCYSTOP
2
`A'Frame
BUTTONSARENOTACTIVE
Selected in Neutral
OVERRIDEBUTTONONLYACTIVE
Deploy/Stow
Park Brake on
WITHROTARYSWITCHINPOSN2+4
OVERRIDERESETSTOOFFWHEN
Slide Frame
3
XDCDCSSFGEPOSNCHANGED
Extend/Retract
RESETE-STOPATINTERFACEPANEL
AFTERPUSHINGTHISBUTTON
RequiresTransmission
4
Build
Selected in Neutral.PB on
686A660
Figure 4.1 Position Switch in Cab
4-6
