TM-5-5420-279-10
Tail Lift Pendant
4.3.2.24
Release the SWING DOWN switch when the far bank support is fully extended.
4.3.2.25
Insert the upper shootbolt and lock in place with an R clip. If necessary, adjust the
position of the tail lift platform to move the far bank support to align the holes and
facilitate installation of the shootbolt.
4.3.2.26
On the tail lift pendant, operate the SWING DOWN switch to lower the tail lift away
from the far bank support.
Deploying the A-frame
WARNING
HYDRAULIC EQUIPMENT. OPERATION OF EQUIPMENT POWERED BY HYDRAULIC
PRESSURE IS HAZARDOUS. KEEP CLEAR OF MOVING PARTS.
HYDRAULIC PRESSURE. EXPOSURE TO HYDRAULIC FLUID UNDER PRESSURE IS
HAZARDOUS. IN THE EVENT OF A HOSE OR COMPONENT FAILURE, REMOVE ALL
FLUID CONTAMINATION FROM THE SKIN AND EYES WITH CLEAN WATER AND SEEK
MEDICAL ASSISTANCE.
4.3.3.1
Remove the two A-frame leg hinge pins and clips located at the upper cross member
locking plate from either side of the A-frame, two (upper and lower) on the left hand
side and 2 (upper and lower) on the right hand side.
4.3.3.2
On the interface enclosure, if necessary, press the A-frame PARK button to release
the pins.
