TM-5-5420-279-10
WARNING
HYDRAULIC EQUIPMENT. OPERATION OF EQUIPMENT POWERED BY HYDRAULIC
PRESSURE IS HAZARDOUS. KEEP CLEAR OF MOVING PARTS.
HYDRAULIC PRESSURE. EXPOSURE TO HYDRAULIC FLUID UNDER PRESSURE IS
HAZARDOUS. IN THE EVENT OF A HOSE OR COMPONENT FAILURE, REMOVE ALL
FLUID CONTAMINATION FROM THE SKIN AND EYES WITH CLEAN WATER AND SEEK
MEDICAL ASSISTANCE.
4.7.2.2
Position pinning operatives on the decking panels of the slide frame at each side of
the launch frame.
4.7.2.3
On the chest pack, move the joystick forward or rearward as necessary to adjust the
launch beam angle to a suitable height for the pinner.
WARNING
CRUSH HAZARD. DEATH OR PERSONAL INJURY CAN RESULT IN THE EVENT OF A
SUSPENDED LOAD FALLING FROM THE CRANE. DO NOT STAND CLOSE TO LOADS
SUSPENDED FROM THE CRANE.
4.7.2.4
Position the chest pack operator with a clear all-round view but clear of the traverse
path of loads suspended from the crane before commencing launch beam
deployment.
NOTE
It may be necessary to carry out steps 4.7.2.6 and 4.7.2.7 to remove the locking pins.
4.7.2.5
Remove the R clip and the locking pin to release the launch beam final stop.
NOTE
Carry out the following TWO STEPS ONLY if difficulty is experienced removing the locking
pin.
4.7.2.6
On the chest pack, move the joystick to the right to select the beam drive function.
Make sure the POWER and BEAM DRIVE captions on the chest pack display
illuminate.
4-35
