TM-5-5420-279-10
WARNING
CRUSH HAZARD. DEATH OR PERSONAL INJURY CAN RESULT IN THE EVENT OF A
SUSPENDED LOAD FALLING FROM THE CRANE. DO NOT STAND CLOSE TO LOADS
SUSPENDED FROM THE CRANE.
5.4.2.2
Operate the lift and traverse controls on the crane, and position the bridge module
lifter at the home bank ramp module.
5.4.2.3
Connect the bridge module lifter to the front lifting points (POSITION 1) on the
outboard sides of the home bank ramp module box sections.
Bridge Module Lifter Connected to POSITION 1 on Ramp Module
5.4.2.4
Operate the LIFT UP switch, on the tail lift pendant, to position the pinning
operatives at the optimum convenient height.
5.4.2.5
Attach one tag line to the ramp module and one to the parallel module.
5.4.2.6
Remove the retaining clips and the pins connecting the home bank ramp module to
the end parallel module and place them on the tail lift.
5.4.2.7
Operate the controls on the crane until the shootbolts can be retracted.
Disengage the shootbolts from the home bank ramp module and the end of the 1st
5.4.2.8
parallel module.
5.4.2.9
Operate the crane to separate the two modules.
WARNING
CRUSH HAZARD. DEATH OR SEVERE INJURY COULD RESULT IF PERSONNEL STAND
BETWEEN THE SUSPENDED LOAD AND THE MODULE LOCATED ON THE LAUNCH
FRAME.
5.4.2.10
Insert the pins and retaining clips already removed into the lugs on the home bank
ramp module and parallel module inner jaws, from the inside out (2 per module).
5.4.2.11
Operate the LIFT DOWN switch on the tail lift pendant to lower the pinning
operatives to the ground.
5-15
