TM-5-5420-279-10
Table 8.2 Operators PMCS (Before) - (continued)
Location
Not Fully Mission
Item
Item to
Procedure
Interval
Capable If:
No.
Check
Service
TRANSFER CASE
LOCKUP
ENGAGE ONLYWHEN CTIS/LOCKUP
SELECTION DOES NOT PROVIDE
3
2
SUFFICIENTTRACTION FOR CONDITION.
RETURNTRANSFER CASETOTHE
UNLOCKED POSITION AS SOON AS
CONDITIONS ALLOW
4
CAUTION
DO NOT ENGAGETRANSFER CASE1
LOCKUPWHILEWHEELS ARE SLIPPING
ORWHENTURNING A CORNER,
DAMAGETO DRIVELINE MAY RESULT
ROTARY SWITCH
12V DC
24V DC
EMERGENCY STOP OVERRIDE
AUX
AUX
Pos
Function
WARNING
1
Highway
Check Aux
Light Off
WHEN SET, EMERGENCY STOP
2
`A'Frame
BUTTONS ARE NOT ACTIVE
Selected in Neutral
OVERRIDE BUTTON ONLY ACTIVE
Deploy/Stow
Park Brake on
WITH ROTARY SWITCH IN POSN 2 + 4
OVERRIDE RESETSTO OFFWHEN
Slide Frame
3
XDCDC SSFGE POSN CHANGED
Extend/Retract
RESET E-STOP AT INTERFACE PANEL
AFTER PUSHINGTHIS BUTTON
Requires Transmission
4
Build
Selected in Neutral. PB on
686A660
69
Before
Cab
Set four position switch to position 1
check that:
(a) Neutral lock up disengages.
Neutral lock up does
not disengage.
(b) Engine RPM drops to idle.
RPM does not drop
to idle.
70
Before
Cab
Switch off engine in accordance with
TM 9-2320-364-10.
71
Before
Top man
(a) Check for damage or cuts to
Damage or cuts
safety
harness assembly.
apparent.
harness
and lanyard
(b) Inspect Scaffold hook and
Distortion or damage
karabiner for distortion or damage.
apparent.
(c) Check all buckles for distortion or
Distortion or damage
damage.
apparent.
NOTE
If any damage or wear is found on the top man safety harness and lanyard, or if in doubt
about the condition of the equipment, withdraw the equipment immediately from service
and seek advice from your supervisor on the subsequent action to be taken.
8-30