TM-5-5420-279-10
TS 007 - Ramp Module - End Beam Will Not Locate
End Beam will not
locate in the
Ramp module
Lower the module
Are the
and re-sling to the
correct slinging points on
No
correct sling
the ramp Module being
points
used
Yes
Ensure that the
Is the
Ramp Module is
Ramp Module aligned
No
perpendicular to
correctly
the End Beam
Rock the End
Beam using the
Yes
handles to assist
alignment
Are the
Remove the End
End Beam
Beam
Yes
Pins
Pins
inserted
No
Are the
Remove
End beam 'U' blocks
Yes
obstruction
obstructed
No
Tighten the slide
Are the
slide pad screws
pad screws
Yes
Chapter 10
protruding
Proc. 10.15
No
Replace End
Has fault been
No
Beam
rectified
Yes
Continue with build
procedure
