TM 5-5420-280-10
0029 00
MANUALLY UNLOADING PALLET TO GROUND (Contd)
CAUTION
High idle switch must be in the OFF position prior to
engaging PTO. Failure to comply may result in damage
to the vehicle transmission or the LHS.
15. With HIGH IDLE switch (5) in OFF position, turn PTO ENGAGE switch (3) to
ON position. PTO ENGAGE indicator (4) will light.
WARNING
When the NO TRANSIT WHEN LIT indicator is
illuminated, the CBT may be maneuvered in the
immediate vicinity of the loading/unloading site, but
should not be driven on the open road. Failure to comply
may result in damage to equipment and possible injury
or death to personnel.
Ensure fastening rods are installed and secure, and there
is sufficient overhead clearance to unload pallet or
damage to equipment or possible injury or death to
personnel may result.
All non-essential personnel will stand a minimum of
30 ft (9 m) away from pallet and bridge during loading
and unloading operations. Failure to comply may result
in injury or death to personnel.
CBT will roll forward when unloading pallet to ground.
All personnel must stand clear. Failure to comply may
result in serious injury.
NOTE
The LHS ENGAGED indicator will light up whenever
the joystick is held in the LOAD or UNLOAD position.
16. Hold joystick (8) in UNLOAD position until LHS hook arm (9) raises
pallet (10) and completes its full movement rearward, then release joystick (8).
NO TRANSIT WHEN LIT indicator (7) will light.
17. Push PARKING BRAKE control (1) in, and take foot off service brake (2).
18. Turn LHS MODE SELECT switch (6) to MAIN FRAME ONLY (position 3).
1
2
0029 00-8