TM 5-5420-280-23&P
0033 00
PALLET FRONT WHEEL ASSEMBLY REPLACEMENT (Contd)
INSTALLATION
NOTE
Apply a light coat of grease to bushings, steering shaft, guide
plates, and slide bracket at installation.
1.
If removed, install twelve guide plates (10) on wheel mounting bracket (12) with twenty-four
screws (11).
2.
Install two bushings (17) on wheel mounting bracket (12) and lube fitting (19) on wheel spindle
bracket (18).
3.
Slide wheel mounting bracket (12) up in slide bracket (7) and through cylinder rod end (8).
4.
Position wheel spindle bracket (18) between bushings (17), and install steering shaft (9) through
bushings (17) and wheel spindle bracket (18).
NOTE
Ensure that all mounting hardware is tightened to metric standards
unless otherwise noted. Refer to metric torque limits in WP 0118 00.
5.
Install four nuts (13) and cylinder rod ends (8) on wheel mounting bracket (12).
6.
If removed, install bushing (14) on bottom retaining plate (15) and install bottom retaining
plate (15) on slide bracket (7) and steering shaft (9) with four screws (16).
NOTE
Ensure steering arm is positioned on steering shaft as marked
during removal.
7.
Install snapring (20) on steering shaft (9), and place steering arm (3) on steering shaft (9).
8.
If removed, install bushing (21) on top retaining plate (1), and install top retaining plate (1) on
steering shaft (9) and slide bracket (7) with four screws (2).
9.
Connect steering rod end (4) to steering arm (3) with washer (5) and new cotter pin (6).
10.
Apply grease to lube fitting (19).
11.
Install pallet wheel hub. Refer to WP 0037 00.
0033 00-4
