TM 5-5420-280-23&P
0064 00
WINCH ROPE LOOP SENSOR AND FORCE TRANSMITTER REPLACEMENT (Contd)
REMOVAL
NOTE
Perform steps 1 and 2 to remove winch rope loop sensor and steps 3
through 5 to remove force transmitter.
1. Disconnect rope loop sensor (2) and electrical connector (1) from main harness.
2. Loosen jamnut (3) and remove sensor (2) from sensor holder bracket (4) on rope guide (5).
3. Disconnect electrical connector (15) from force transmitter (9).
4. Remove two screws (11), washers (12), and slide locking bracket (13) out of slot (10) on
transmitter (9).
5. Push transmitter (9) out of winch mounting bracket (8) and transmitter holder (14).
INSTALLATION
NOTE
Perform steps 1 through 3 to install force transmitter and steps 4
and 5 to install rope loop sensor.
Apply a light coat of grease to housing of force transmitter at
installation.
1. Slide force transmitter (9) through winch mounting bracket (8) and transmitter holder (14) until
slot (10) is aligned with locking bracket (13) screw holes.
NOTE
Apply a light coat of sealing compound to threads of screws at
installation.
2. Position locking plate (13) in slot (10) on force transmitter (9), align screw holes and install two
washers (12) and screws (11).
3. Connect electrical connector (15) to transmitter (9).
NOTE
Apply a light coat of antiseize compound to threads of sensor at
installation.
4. Install rope loop sensor (2) on sensor holder bracket (4) finger tight.
5. Connect rope loop sensor (2) and electrical connector (1) to main harness and remove two screws (7),
washers (6), and rope loop sensor bracket (4) to perform adjustment before tightening jamnut (3).
0064 00-2
