TM 5-5420-280-23&P
0065 00
WINCH ELECTRICAL HARNESS, CONTROL CABLE, AND POWER SUPPLY CABLE REPLACEMENT (Contd)
WINCH ELECTRICAL HARNESS REMOVAL
NOTE
Tag all electrical leads for installation.
1. Disconnect winch electrical harness connector No. 100 (4) from electronic box receptacle (5) on
electronic box (6).
2. Loosen screw and disconnect electromagnet motor connector No. 3 (8) from shift valve solenoid
receptacle (20). Remove and discard gasket (7).
3. Loosen screw and disconnect proportional valve connector No. 67 (9) from proportional throttle
solenoid receptacle (25). Remove and discard gasket (7).
4. Loosen screw and disconnect pressure control valve connector No. 66 (10) from pressure relief valve
solenoid receptacle (18). Remove and discard gasket (7).
5. Loosen screw and disconnect control valve rope-out connector No. 6 + 8 (11) from rope in/out control
valve solenoid receptacle (17). Remove and discard gasket (7).
6. Disconnect rope loop sensor connector No. 7 (12) from rope loop monitoring sensor (21).
7. Disconnect pressure sensor connector No. 63 (13) from pressure sensor (19).
8. Disconnect force transmitter connector No. 78 (14) from force transmitter receptacle (16).
9. Disconnect distributor cable connector No. 17/1 + 61 (15) from distributor cable receptacle (24) on
winch electrical harness (3).
10. Disconnect distributor cable connector No. 17/1 (2) from reduced pulling force sensor (22).
11. Disconnect distributor cable connector No. 61 (1) from signal winch ON sensor (23).
12. Remove tie-down straps as necessary and remove winch electrical harness (3) and distributor cable
from winch assembly.
0065 00-2
