TM 5-5420-280-23&P
0107 00
ENGINE OIL FILTER REPLACEMENT (Contd)
REMOVAL
1.
Remove four forward engine mounting screws (8) and lockwashers (7) from engine support
bracket (6) and engine oil pan (5). Discard lockwashers (7).
2.
Lift engine (3) off support bracket (6) to remove oil filter (9).
NOTE
Have container ready to catch oil.
3.
Turn oil filter (9) counterclockwise and remove oil filter (9) from engine (3). Discard oil filter (9).
4.
Remove mesh screen (1) from safety relief valve (2).
WARNING
Skysol 100 mixture is combustible. Use mechanical ventilation
whenever product is used in a confined space, is heated above
ambient temperatures, or is agitated. DO NOT use or store near
heat, sparks, flame, or other ignition sources. Keep container sealed
when not in use.
Contact with Skysol 100 may cause skin irritation. Use chemical-
resistant gloves. In case of skin contact, remove any contaminated
clothing and wash skin thoroughly with soap and water. wash
contaminated clothing before reuse. Eye contact may cause
irritation, tearing, or blurring of vision. Use face shield or goggles
when eye contact may occur. In case of eye contact, flush eyes with
large amounts of water for at least fifteen (15) minutes or until
irritation subsides. Inhalation may cause irritation to upper
respiratory passages. DO NOT have food or drink in the vicinity.
Failure to comply may result in injury to personnel.
5.
Clean mesh screen (1) and filter base (4) with Skysol 100.
INSTALLATION
NOTE
Apply a light coat of engine oil to oil filter seal at installation.
1.
Install mesh screen (1) on safety relief valve (2).
2.
Install oil filter (9) on engine (3) and tighten oil filter (9) clockwise hand tight.
3.
Lower engine (3) down onto engine support bracket (6).
4.
Align holes in support bracket (6) with holes in oil pan (5) and install four new lockwashers (7) and
screws (8).
5.
Start engine and check for oil leaks. Refer to TM 5-5420-280-10.
1
2
3
4
5
9
6
7
8
END OF WORK PACKAGE
0107 00-2
