TM 55-1945-205-10-40009 00 20009 00a. Insert crowbar (2) behind the spring bar (3) under the female guillotine connector (1).b. Rotate the crowbar (2) downward to clear spring bar (3) from deck overhangs (4) and allow the femaleguillotine connector (1) to move upward.c. Raise the female guillotine connector (1) approximately 6 in. until it stops.2. Raise the male guillotine connectors (5).a. Insert crowbar (2) behind the spring bar (6) under the male guillotine connector (5).b. Rotate the crowbar (2) downward to clear spring bar (6) from deck overhangs (7) and allow male guillotineconnector (5) to move upward.NOTEPersonnel should hear two clicks as both pins extend or, if the module is in the water,personnel should see the first pin extend and continue to pull up until one can hear or feelthe second lower pin extend.c. Raise the male guillotine connector (5) approximately 6 in. until it stops, allowing male connector pins tofully extend.d. Remove the crowbar (2).e. Drive the guillotine connector (5) back into stowed position using a sledgehammer to secure the maleconnector pins (8) in the fully extended position.2567
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
