TM 55-1945-205-24-2
0326 00 6
0326 00
a.
Remove four screws (13) securing pickup assembly (14) to oil reservoir (15).
WARNING
b.
Remove pickup assembly (14) from oil reservoir (15).
WARNING
c.
Remove pickup filter (16) from the bottom of the pickup assembly (14) and clean using a wiping
rag and cleaner.
d.
Install pickup filter (16) on bottom of pickup assembly (14).
e.
Loosen hose clamp (17) and remove pickup hose (18) from bottom of the pickup assembly (14).
WARNING
f.
Remove oil inlet hose (19) from lower housing cover (20) by loosening hose clamp (21).
WARNING
g.
Use low pressure air from an air compressor to remove residual oil from oil inlet hose (19) into a drain pan.
h.
Install cap holder (22) on the pickup assembly end of pickup hose (18).
i.
Connect a vacuum tester gage and hose (23) to the engine end of oil inlet hose (19) and draw a
7 in. Hg vacuum.
j.
Verify the 7 in. Hg vacuum maintains for at least 5 minutes, indicating a good pickup by the oil supply system.
k.
Verify the pickup assembly height (A) for the 1.8 gal oil reservoir to be 6.84 - 6.96 in.