TM 55-1945-205-24-20061 00 40061 003.Back roll each coat while wet at a 90° angle to evenly spread the texture.NOTECold temperatures or high humidity will retard drying time. 4.Allow to dry tack free, approximately 3 hours at 70°F.WARNINGCAUTIONDo not apply anti-skid coating to air test plug ports, lift castings and shackles and connector castings.NOTEApplication temperature range limits are 40° - 120°F.No coating should be done if the surface is likely to be damaged by rain, fog, dew or dust, etc., during the drying period.5.Apply a second coat of anti-skid coating, after the first coat is completely tack free.NOTECold temperatures or high humidity will retard drying time. 6.Allow anti-skid coating to dry 96 hours before heavy traffic or equipment is used on it.PAINT COMBINATION BEACH/SEA END SECTION NON-POWERED MODULE CLEATS, D-RINGS, GUILLOTINE CONNECTORS, RHINO HORNS, AND FLEXOR ASSEMBLIESCAUTIONDo not prime or paint rubber surfaces of flexor assemblies.1.Mask off areas to be painted.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
