TM 55-1945-205-24-2
0261 00 3/4 blank
0261 00
WARNING
7.
Remove the hose couplings (7) from the helm fittings (5).
8.
Remove hoses (1) through the hole in the bottom rear of the operators seat (8) and discard.
WARNING
9.
Remove drain pan and dispose of contents in accordance with local procedures.
INSTALL RHIB POWER STEERING HOSES
1.
Feed new power steering hoses (1) through hole in bottom rear of operators seat (8).
2.
Stretch hoses (1) between the hydraulic cylinder (2) and helm fittings (5).
3.
Install the hose couplings (7) on helm fittings (5) and tighten.
4.
Install the hose couplings (4) on the hydraulic cylinder (2) and tighten.
5.
Install all hose clamps and new tiedown straps to secure hoses (1) in place.
WARNING
6.
Clean up spilled fluid with a spill kit and dispose of spill kit waste in accordance with local procedures.
7.
Service the power steering reservoir. (WP 0260 00)
8.
Install RHIB battery negative lead terminal. (WP 0336 00)
9.
Perform operational check of RHIB. (TM 55-1945-205-10-2)
END OF WORK PACKAGE
