TM 55-1945-205-24-2
0281 00 9/10 blank
0281 00
d.
Apply a thin second coat of glue from repair kit to the inflatable tube (1).
e.
Apply a thin second coat of glue from repair kit to the contact surface of patch (2).
CAUTION
Glue drying times may vary due to temperature and humidity, ensure the glue is
tacky before applying third coat. Failure to comply could result in a failed patch and
cause damage to equipment.
f.
Allow glue to dry for five to ten minutes or until tacky.
g.
Apply a thin third coat of glue from repair kit to the inflatable tube (1).
h.
Apply a thin third coat of glue from repair kit to the contact surface of patch (2).
CAUTION
Glue drying times may vary due to temperature and humidity, ensure the glue is
tacky before applying the patch to the inflatable tube. Failure to comply could result
in a failed patch and cause damage to equipment.
i.
Allow the glue to dry for five to ten minutes or until tacky.
27. Lay patch (2) on the cut in the seam tape (3) with out pressing down on the patch (2).
28. Adjust the position of patch (2) so that it is centered over the cut in the seam tape (3).
29. Using a fid, start from center of patch and move outward removing any air bubbles that have formed
under patch.
30. Allow 12 hours drying time before inflating inflatable tube.
END OF WORK PACKAGE
