TM 55-1945-205-24-20286 00 5/6 blank 0286 00d.Apply a thin second coat of glue from the repair kit to inner bonding surface of the inflatable tube (1).e.Apply a thin second coat of glue from the repair kit to the contact surface of outer patch (3).CAUTIONGlue drying times may vary due to temperature and humidity, ensure the glue is tacky before applying third coat. Failure to comply could result in a failed patch and cause damage to equipment.f.Allow the glue to dry for 5-10 min. or until tacky.g.Apply a thin third coat of glue from the repair kit to inner bonding surface of the inflatable tube (1).h.Apply a thin third coat of glue from the repair kit to the contact surface of outer patch (3).CAUTIONGlue drying times may vary due to temperature and humidity, ensure the glue is tacky before applying the patch to the inflatable tube. Failure to comply could result in a failed patch and cause damage to equipment.i.Allow the glue to dry for 5-10 min. or until tacky.20. Lay the outer patch (3) on the damaged area of the inflatable tube (1) without pressing down on the outer patch (3).21. Adjust the position of the outer patch (3) so that it is centered over the damaged area.22. Using a fid, start at the center of the outer patch (3) and move outward removing any air bubbles that haveformed under the outer patch (3).23. Allow 12 hours to drying before testing the inflatable tube (1) for air retention. (WP 0280 00)END OF WORK PACKAGE
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
