TM 55-1945-205-24-2
0306 00 3/4 blank
0306 00
f.
With throttle in wide open position, use starter to crank engine through a minimum of four
compression strokes.
g.
Check compression in each cylinder for a pressure variation between cylinders not to exceed
15 PSI (100 kPa).
h.
If engine does not have equal compression between the cylinders, contact depot maintenance for repair.
WARNING
3.
Using cleaner, spray each cylinder through the spark plug hole to dissolve carbon deposits.
4.
Allow internal engine components to soak in carbon removing compound between 3 to 16 hours.
WARNING
5.
After soaking, run RHIB engine at fast idle (1500 RPM) for at least 15 minutes to remove deposits.
6.
Allow RHIB engine to cool down.
7.
Install new RHIB engine spark plugs. (WP 0307 00)
8.
Install new RHIB engine spark plug wires. (WP 0308 00)
9.
Adjust RHIB throttle synchronization and linkage. (WP 0271 00)
10. Install RHIB engine cover. (WP 0297 00)
11. Install RHIB battery negative terminal lead. (WP 0336 00)
END OF WORK PACKAGE
