• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENGINE WIRING INTERCONNECT HARNESS REPLACEMENT INSTRUCTIONS (cont)
MAST WIRING HARNESS REPLACEMENT INSTRUCTIONS - LOWER

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  125    126    127    128    129  130  131    132    133    134    135  
TM 5-1940-277-34 ENGINE WIRING INTERCONNECT HARNESS REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS NOTE Carefully feed harness through supports as cord is being pulled. b. Route harness Keep harness from battery straight and feed compartment by hand through along star- support tubes board side to welded on star- control con- board side of sole. boat while pulling at same time on cord. 5. Control box Connector plug Connect plug to Push plug into (6) receptacle on receptacle and bottom of con- hand tighten re- trol box. taining ring on plug. NOTE Wire identification and pin callout are contained on the wiring diagram. 6. Control console Harness connec- Connect plug to Use hands to turn tor (1) receptacle on retainer ring. interconnect harness by screwing on retainer ring. 2-119 (2-120 Blank)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.