• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENGINE WIRING INTERCONNECT HARNESS REPLACEMENT INSTRUCTIONS - TM-5-1940-277-34_144
ENGINE WIRING INTERCONNECT HARNESS REPLACEMENT INSTRUCTIONS (cont)

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  123    124    125    126    127  128  129    130    131    132    133  
TM 5-1940-277-34 ENGINE WIRING INTERCONNECT HARNESS REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS REMOVAL 1. Control console a. Harness a. Disconnect by Use hands. connector unscrewing (1) retaining ring on plug (2) and pulling plug from receptacle. b. Fasten cord Tie and tape to end of cord for use in harness. replacing new harness. NOTE Carefully feed cord as harness is being removed. 2. Battery Interconnect Pull harness Pull harness by compartment harness (3) out of support hand aft from tubes (4) welded starboard side on starboard of battery side of boat. compartment. 3. Control box (5) Connector plug Disconnect by Use hands. (6) unscrewing retaining ring on plug and pulling down on plug. INSTALLATION 4. Battery Harness connec- a. Fasten cord Tie and tape cord compartment tor receptacle to harness. to harness. (1) 2-117







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.