• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
CYLINDER LINER INSPECTION AND REPLACEMENT INSTRUCTIONS (cont) - TM-5-1940-277-34_474
CYLINDER LINER INSPECTION AND REPLACEMENT INSTRUCTIONS (cont) - TM-5-1940-277-34_476

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  453    454    455    456    457  458  459    460    461    462    463  
TM 5-1940-277-34 CYLINDER LINER INSPECTION AND REPLACEMENT INSTRUCTIONS (Continued) 4. Cylinder liner Check roundness. (2) a. Calculate difference in diameters at each level (sub- tract diameter measured at 0° from that measured at 90) in bore measured in a above. b. Replace if measurements are not within 0.003 in. (0.075 mm) of each location. INSTALLATION: 5. Cylinder block a. Cylinder a. Remove all Use wire brush. (1) bore (4) foreign matter by lightly brushing. b. Remove all Use solvent. traces of dust and oil. c. Apply 0.5 in. (13 mm) wide band of sealer (5) at bottom (see figure). 3-43







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.