• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
CYLINDER LINER INSPECTION AND REPLACEMENT INSTRUCTIONS (cont) - TM-5-1940-277-34_476
MAIN BEARING INSPECTION AND REPLACEMENT INSTRUCTIONS

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  455    456    457    458    459  460  461    462    463    464    465  
TM 5-1940-277-34 CYLINDER LINER INSPECTION AND REPLACEMENT INSTRUCTIONS (Continued) b. Cylinder a. Remove Use honing unit. liner (2) protective coating (new liner only). b. Apply 0.5 in. Use sealer. (13 mm) wide band of sealer (6) below cylinder liner lip (see figure). c. Push into Make sure liner cylinder bore recess in block as far as remains clean possible by allowing liner to hand. seat correctly. d. Press home Use cylinder squarely. liner remover and replacer. e. Remove any sealer accumu- lated at bottom of liner. f. Check piston Follow step 3 to liner for procedure. clearance - 0.0058 to 0.0068 in.   (0.15 to 0.17 mm). g. If necessary Use cylinder hone to honing unit. clearance specification. 3-45 (3-46 Blank)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.