• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
CYLINDER LINER INSPECTION AND REPLACEMENT INSTRUCTIONS (cont) - TM-5-1940-277-34_472
CYLINDER LINER INSPECTION AND REPLACEMENT INSTRUCTIONS (cont) - TM-5-1940-277-34_474

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
  451    452    453    454    455  456  457    458    459    460    461  
TM 5-1940-277-34 CYLINDER LINER INSPECTION AND REPLACEMENT INSTRUCTIONS (Continued) o At 7.9 in. (200 mm) below top face of block. b. Calculate each average cylin- der liner dia- meter of 6 measurements. c. Measure pis- Use micrometer ton diameter caliper, outside. at 0.95 in. (24.13 mm) up from lower piston edge at 90 to and in line with piston pin axis (see figure). d. Calculate average piston diameter of 2 measurements. e. Calculate This is dif- clearance. ference between average liner diameter and average piston diameter. f. Replace liner if clearance not within limits 0.0058 to 0.0068 in.  (0.147 to 0.172 mm). 3-41







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.