• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
SHIFT LINKAGE ADJUSTMENT - Continued
SHIFT LINKAGE ADJUSTMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  533    534    535    536    537  538  539    540    541    542    543  
img
TM 5-5420-226-20-3
SHIFT LINKAGE ADJUSTMENT (Sheet 19 of 28)
NOTE
Do not allow shifting rod (BB) to turn while doing
step 97. Shifting rod (BB) is made up of more than
one piece and may come apart if allowed to turn.
97.
Using 9/16 inch wrench, adjust shifting rod
bearing rod end (BC) by turning clockwise
or counterclockwise until screw (AZ) will
drop freely through clevis (BA) and shifting
rod bearing end (BC).
98.
Using 9/16 inch wrench, install screw (AZ).
Holding rod bearing end (BC) with 9/16 inch wrench, use torque wrench and 9/16 inch
99.
crow foot adapter to tighten jamnut (AX) to 16-18 lb-ft (22-24 N·m).
Remove locating pin (AU) from alinement holes.
100.
Using torque wrench and 9/16 inch socket, tighten screw (AZ) to 16-18 lb-ft (22-24 N·m).
101.
Go on to Sheet 20
TA169072
11-71






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.