TM 5-1940-277-34
TRANSMISSION REPAIR INSTRUCTIONS (Continued)
LOCATION
ITEM
ACTION
REMARKS
25. Arbor press table
a. Pinion cage
Place assembly
Use bearing
and output
with shaft
assembly tool.
shaft assem-
pointing upward
bly (38)
on 5 in diameter
2-7/8 in long
assembly tool which
is resting on arbor
press table.
b. Transmission
Place case over
case (47)
shaft and tool so
case rests squarely
on arbor press
table.
26. Pinion cage
Annular bearing
a. Lubricate all
and shaft
(46)
parts with
assembly (38)
clean engine
oil before
assembly.
Move case as
necessary to
aline shaft,
bearing and
case.
b. Place bearing
with groove in
outer diameter
away from trans-
mission case
over shaft and
squarely in
bearing bore on
case.
c. Press bearing
Use arbor press
down until
and bearing
seated against
assembly tool
shaft or case
which is locally
shoulder.
fabricated
(refer to
Appendix C).
3-125
