ASSEMBLY (cont) - TM-5-1940-277-34

TRANSMISSION REPAIR INSTRUCTIONS (cont) - TM-5-1940-277-34_558

TRANSMISSION REPAIR INSTRUCTIONS (cont) - TM-5-1940-277-34_560

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
542

TM 5-1940-277-34 TRANSMISSION REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS b. Main shaft a. Install and nut (39) torque to 140 - 150 ft-lb. b. After tighten- There should be ing remove no detectable assembly from end play in vise. coupling-output shaft combina- tion. NOTE Transmission case-pinion cage output shaft subassembly should be placed on work surface with face up and resting on coupling face to be ready for further assembly. 30. Ring gear (18) a. Clutch pres- a. Place ring The clutch pres- sure plate gear on clean sure plate should surface with seat firmly and (rear) (37) external squarely on teeth up. shoulder at bot tom of internal splines. This is b. Place clutch above internal pressure helical teeth. plate, smooth- ly ground face up, into ring gear Change 1 3-129

Privacy Statement
Press Release
Contact