TM 5-1940-322-24
FIELD MAINTENANCE INSTRUCTIONS
BRIDGE ERECTION BOAT (BEB)
MK II-S
P/N 12492423
SERVICE UPON RECEIPT
GENERAL, GENERAL INSPECTION AND SERVICING INSTRUCTIONS,
AND SPECIFIC INSPECTION AND SERVICING INSTRUCTIONS
GENERAL
Upon receipt of a new, used, or reconditioned boat, refer to TM 5-1940-322-10 and perform the following
steps to determine if the boat has been properly prepared for service.
NOTE
The operator will assist when performing service upon receipt
inspections.
1.
Inspect all assemblies, subassemblies, and accessories to ensure they are in proper working order.
2.
Secure, clean, lubricate, or adjust equipment as indicated in the Preventive Maintenance Checks and
3.
Check all Basic Issue Items (BII) to ensure every item is present, in good condition, and properly
mounted or stowed (TM 5-1940-322-10).
GENERAL INSPECTION AND SERVICING INSTRUCTIONS
Refer to TM 5-1940-322-10 and other WPs in this manual when servicing, inspecting, and lubricating
equipment.
WARNING
Skysol 100 mixture is combustible; DO NOT use or store near heat,
sparks, flame, or other ignition sources. Use mechanical ventilation
whenever product is used in a confined space, heated above
ambient temperatures, or agitated. Keep container sealed when not
in use. Failure to do so may result in injury to personnel.
Contact with Skysol 100 may cause skin irritation. Use chemical-
resistant gloves. In case of skin contact, remove any contaminated
clothing and wash skin thoroughly with soap and water. Wash
contaminated clothing before reuse. Eye contact may cause
irritation, tearing, or blurring of vision. Use face shield or goggles
when eye contact may occur. In case of eye contact, flush eyes with
large amounts of water for at least 15 minutes or until irritation
subsides. Inhalation may cause irritation to upper respiratory
passages. DO NOT have food or drink in the vicinity. Failure to do
so may result in injury to personnel.
Use Skysol 100 to clean all exterior surfaces coated with rust-preventive compounds.
0009 00-1