TM 5-1940-322-24
0022 00
CAB CLAMP MAINTENANCE (Contd)
NOTE
There are six cab clamps on the boat. Four cab clamps are located
outside of cab and two are located inside of cab. All cab clamps are
replaced the same way. This procedure covers the replacement of
one clamp.
REMOVAL
1. Release clamp (2) from cab (6).
2. Remove four locknuts (3), eight washers (5), four screws (1), spacer (4), and clamp (2). Discard
locknuts (3).
INSTALLATION
1. Align clamp (2) with existing holes in cab (6).
2. Install clamp (2) with spacer (4), four screws (1), eight washers (5), and four new locknuts (3).
ADJUSTMENT
WARNING
Use caution when closing clamps. Ensure hands are kept clear of
clamping area. Failure to comply may result in injury to personnel.
If necessary, adjust clamp (2) by turning bolt (7) and aligning it with catch (8). Secure cab (6) by closing
clamp (2).
0022 00-2
