TM 5-1940-322-24
0025 00
WINDSHIELD WIPER ARM REPLACEMENT (Contd)
NOTE
Both wiper arms are replaced the same way. This procedure covers
the replacement of one wiper arm.
REMOVAL
CAUTION
Hold wiper assembly while removing. Failure to comply may result
in damage to equipment.
1. Remove nut (6) and wiper arm (4) from post (1).
2. Remove nut (5) and idler arm (3) from post (2) while holding wiper assembly.
3. Inspect windshield wiper blade for damage, replace if necessary (WP 0024 00).
INSTALLATION
1. Install idler arm (3) on post (2) with nut (5). Tighten nut (5) to 50 lb-in. (5.65 Nm).
2. Install wiper arm (4) on post (1) with nut (6). Tighten nut (6) to 90110 lb-in. (10.1712.43 Nm).
CAUTION
Do not run wiper on dry windshield for more than one or two
strokes. Failure to comply may result in wiper blade and/or
windshield damage. Wet down windshield if further testing is
required.
4. Test windshield wipers (TM 5-1940-322-10).
1
2
6
5
4
3
END OF WORK PACKAGE
0025 00-2