TM 5-1940-322-24
0026 00
WINDSHIELD WIPER MOTOR REPLACEMENT (Contd)
NOTE
Both windshield wiper motors are replaced the same way. This
procedure covers the replacement of one windshield wiper motor.
REMOVAL
1. Disconnect electrical connector (2) from electrical connector (3) on wiper motor (4).
NOTE
Assistant will help with steps 2 and 3.
2. Remove two screws (8), lockwashers (7), washers (6), and mount (5) from cab (1). Discard
lockwashers (7).
3. Remove windshield wiper motor (4) from inside cab (1).
INSTALLATION
NOTE
Assistant will help with step 1.
1. Install windshield wiper motor (4) on mount (5) with two washers (6), new lockwashers (7), and
screws (8). Tighten screws (8) to 140180 lb-in (1520 Nm).
2. Connect electrical connector (2) to electrical connector (3) of wiper motor (4).
3. Install windshield wiper arm (WP 0025 00).
CAUTION
Do not run wiper on dry windshield for more than one or two
strokes. Failure to comply may result in wiper blade and/or
windshield damage. Wet down windshield if further testing is
required.
4. Test windshield wipers (TM 5-1940-322-10).
0026 00-2
