TM 5-1940-322-24
0033 00
SCOOP CONTROL HEAD ASSEMBLY REPLACEMENT (Contd)
NOTE
Tag all cables during removal to assist with installation. This will
allow identification of port and starboard locations.
REMOVAL
1.
Remove four screws (6), washers (4), locknuts (3), and control head assembly (5) from control
panel (1). Discard locknuts (3).
2.
Remove four screws (14), two clamps (13), four washers (12), and nuts (11) from control head
assembly (5).
3.
Remove two cotter pins (8) from cable ends (7). Discard cotter pins (8).
4.
Disconnect cable ends (7) from control head levers (2).
5.
Remove cable ends (7) and nuts (9) from cables (10).
INSTALLATION
1.
Install two nuts (9) and cable ends (7) on cables (10).
2.
Connect cable ends (7) on control head levers (2).
3.
Install two new cotter pins (8) on cable ends (7).
4.
Secure cables (10) on control head assembly (5) with four screws (14), two clamps (13), four
washers (12), and four nuts (11).
5.
Secure control head assembly (5) on control panel (1) with four screws (6), washers (4), four new
locknuts (3).
6.
If necessary, adjust scoop control cables (WP 0034 00).
7.
Close and secure control panel access panel (TM 5-1940-322-10).
0033 00-2
