TM 5-1940-322-24
0034 00
SCOOP CONTROL CABLE MAINTENANCE (Contd)
NOTE
There are two scoop control cables. Both cables are replaced the
same way. This procedure covers the replacement of one scoop
control cable.
REMOVAL
1. Remove cotter pin (13) and pin (12) from clevis (11) and lever (14). Discard cotter pin (13).
2. Remove two screws (8), cable clamp (7), plate (6), washers (4), and locknuts (3) from bracket (2).
Discard locknuts (3).
3. Remove clevis (11) and nut (10) from cable (9).
4. Remove cable (9) from boat (1).
INSTALLATION
NOTE
Attach new cable to existing cable with tape to assist with
installation.
1. Install cable (9) on boat (1).
2. Install nut (10) and clevis (11) on cable (9). Tighten nut (10).
3. Install clevis (11) on lever (14) with pin (12) and new cotter pin (13).
4. Secure cable (9) on bracket (2) with two screws (8), cable clamp (7), plate (6), two washers (4), and two
new locknuts (3).
6. Secure cable (9) on boat (1) with tiedown straps as necessary.
ADJUSTMENT
NOTE
Clevis must be disconnected to check travel.
1. Ensure that cable travel is 3 in. when scoop control head is moved from full ahead to full astern.
2. If cable does not travel 3 in., ensure cable clamp (7) is installed on bracket (2) in correct position (5).
4. Close hydrojet hatches (TM 5-1940-322-10).
5. Close battery hatch (TM 5-1940-322-10).
6. Close engine hatches (TM 5-1940-322-10).
0034 00-2