TM 5-1940-322-24
0035 00
THROTTLE/TRANSMISSION CONTROL HEAD ASSEMBLY REPLACEMENT (Contd)
NOTE
Tag all cables during removal to assist with installation.
REMOVAL
1.
Remove four screws (1), four washers (4), four locknuts (5), and control head assembly (2) from control
panel (3). Discard locknuts (5).
2.
Remove two screws (6) from control head assembly (2). Separate control head assembly (2).
3.
Remove two screws (17) and throttle control cable clamp (16) from control head (2).
4.
Remove E-clip (20) from throttle control lever (18). Discard E-clip (20).
5.
Disconnect throttle control cable end (19) from throttle control head lever (18).
6.
Remove throttle control cable end (19) from throttle control cable (14).
7.
Remove nut (15) from throttle control cable (14).
8.
Remove two screws (13) and transmission control cable clamp (12) from control head (2).
9.
Remove cotter pin (7) from transmission control cable end (8). Discard cotter pin (7).
10.
Disconnect transmission control cable end (8) from transmission control head lever (9).
11.
Remove cable end (8) from transmission control cable (11).
12.
Remove nut (10) from transmission control cable (11).
13.
Perform steps 3 through 12 for remaining half of control head assembly (2).
INSTALLATION
1.
Install nut (10) on transmission control cable (11).
2.
Install cable end (8) on transmission control cable (11).
3.
Connect transmission control cable end (8) on transmission control head lever (9).
4.
Install new cotter pin (7) on transmission control cable end (8).
5.
Secure transmission control cable (11) on control head (2) with cable clamp (12) and two screws (13).
6.
Install nut (15) on throttle control cable (14).
7.
Install cable end (19) on throttle control cable (14).
8.
Connect throttle control cable end (19) on throttle control head lever (18).
9.
Secure throttle control cable (14) on control head (2) with cable clamp (16) and two screws (17).
10.
Install new E-clip (20) on throttle control head lever (18).
11.
Perform steps 1 through 11 for remaining half of control head assembly (2).
12.
Secure control head halves (2) together with two screws (6).
13.
Install control head assembly (2) on control panel (3) with four screws (1), washers (4), and new
locknuts (5).
14.
If necessary, adjust transmission control cable (WP 0037 00).
15.
If necessary, adjust throttle control cable (WP 0036 00).
16.
Close and secure control panel access panel (TM 5-1940-322-10).
0035 00-2
