TM 5-1940-322-24
0061 00
EMERGENCY LINK SOLENOID MAINTENANCE (Contd)
WARNING
Use caution when working with battery cables. Failure to comply
may result in injury to personnel and/or damage to equipment
Remove all jewelry such as rings, identification tags, bracelets, etc.
If jewelry or disconnected battery ground cable contacts battery
positive post, a direct short can result. Failure to comply may result
in injury or death to personnel and/or damage to equipment.
When removing cables, disconnect the ground cable first. Do not
allow tools to come in contact with vehicle when disconnecting
cable clamps. A direct short can result, causing instant heating of
tools, tool damage, battery damage or battery explosion, and severe
injury to personnel.
NOTE
Tag all battery cables and lead wires during removal to assist with
installation.
REMOVAL
1.
Remove two nuts (13), two lockwashers (12), and lead wires (11) and (15) from studs (6) and (14).
Discard lockwashers (12).
2.
Remove two nuts (10), two lockwashers (9), and battery cables (8) and (16) from studs (7) and (17).
Discard lockwashers (9).
3.
Remove two locknuts (18), four washers (3), two screws (4), and emergency link solenoid (5) from
bracket (2). Discard locknuts (18).
4.
Remove two locknuts (1), washers (20), screws (19), and bracket (2) from boat (21). Discard
locknuts (1).
CLEANING AND INSPECTION
1.
For general cleaning and inspection instructions, refer to WP 0013 00.
2.
Inspect battery cables (8) and (16) and lead wires (11) and (15) for damage. Replace if damaged.
3.
Inspect battery cables (8) and (16) and lead wires (11) and (15) for corrosion. If corroded, clean with
wire brush.
4.
Inspect emergency link solenoid (5) for corrosion. If corroded, clean with wire brush.
INSTALLATION
1.
Install bracket (2) on boat (21) with two screws (19), washers (20), and new locknuts (1).
2.
Install emergency link solenoid (5) on bracket (2) with two screws (4), four washers (3), and two new
locknuts (18).
3.
Install lead wires (11) and (15) on studs (6) and (14) with two new lockwashers (12) and two nuts (13).
4.
Install battery cables (8) and (16) on studs (7) and (17) with two new lockwashers (8) and two
nuts (10).
5.
Connect battery ground cables (WP 0054 00).
6.
Close battery hatches (TM 5-1940-322-10).
0061 00-2
