TM 5-1940-322-24
0085 00
BELT GUARD REPLACEMENT (Contd)
NOTE
Belt guards on both engines are replaced the same way. The port
cover has a bracket that holds a cooling pipe that must be
disconnected. This procedure covers replacement of the starboard
engine belt guard.
REMOVAL
1. Disconnect hose (3) and remove four screws (4) and coolant reservoir (2) from belt guard (6).
2. Remove three screws (5) and belt guard (6) from engine (1).
INSTALLATION
CAUTION
Ensure that belt tensioner tang is aligned with hole in engine
bracket before tightening screw. Failure to comply may result in
damage to equipment.
1. Install belt guard (6) on engine (1) with three screws (5). Tighten screws (5) to 18 lb-ft (24 Nm).
2. Install coolant reservoir (2) and hose (3) on belt guard (6) with four screws (4).
3. Close engine hatches (TM 5-1940-322-10).
1
6
5
2
3
4
END OF WORK PACKAGE
0085 00-2
