TM 5-1940-322-24
0128 00
DRIVESHAFT REPLACEMENT (Contd)
CAUTION
Ensure driveshaft is supported during removal and installation.
Failure to comply may result in damage to equipment.
NOTE
Both driveshafts are replaced the same way. This procedure covers
replacement of one driveshaft.
Assistant will help with removal and installation.
REMOVAL
1.
Remove eight locknuts (4) and screws (1) from driveshaft flange (3) and hydrojet drive flange (2).
Discard locknuts (4).
2.
Remove eight locknuts (5) and screws (8) from driveshaft flange (7) and transmission flange (6).
Discard locknuts (5).
INSTALLATION
1.
Apply thin coat of antiseize compound to screws (8) and (1).
2.
Install driveshaft flange (7) on transmission flange (6) with eight screws (8) and new locknuts (5).
Tighten locknuts (5) to 55 lb-ft (75 Nm).
3.
Install driveshaft flange (3) on hydrojet drive flange (2) with eight screws (1) and new locknuts (4).
Tighten locknuts (4) to 38 lb-ft (51 Nm).
4.
Install aft cockpit (WP 0016 00).
0128 00-2
